Penyebaran berminyak HH7025F

• HH–7025F Oily dispersant

This compound is a slightly yellow fine particle, non-toxic, no side effects on the human body, insoluble in most solvents at room temperature, stable to acid, alkali and water media, soluble in hot chlorinated hydrocarbons and aromatic hydrocarbon solvents, its powder has a strong greasy feeling, and is wettable to water above 80℃.

• Data Produk

Komposisi

Contains ultra-large molecular polymers.

Sifat Biasa：

Penampilan: white powder

Initial melting point: 141～146℃

Total amine value: ≤3.0mg KOH/g

Color value: ≤5.0

Nilai asid: ≤7.0mg KOH/g

Heating loss: ≤0.5%

Flash point: ≥28℃

Type: HH7025F

*.Nilai yang ditunjukkan dalam helaian data ini menerangkan sifat biasa dan tidak membentuk had spesifikasi.

• Aplikasi

Ciri-ciri dan Kelebihan Istimewa

• Melting point increaser for petroleum products;
• Lubricant and corrosion inhibitor for metal wire drawing;
• Potting material for electrical components;
• Defoamer and paper coating component for papermaking industry;
• Defoamer and permanent water-removing agent for dyeing engineering in textile dyeing and finishing;
• Adding this product to asphalt can reduce the viscosity of asphalt, improve the softening point, water resistance and weather resistance of asphalt.

• Penggunaan yang disyorkan

HH7025F oily powder dispersant is used in plastics, chemical fibers, release agents, pigmen, filler dispersants, powder coatings, Lapisan, inks and other uses.

Jumlah tambahan

Recommended dosage: 3-5%

*. Data di atas adalah dos empirikal, dan dos optimum perlu ditentukan melalui satu siri ujian.

Arahan Pemerbadanan dan Pemprosesan

Untuk mencapai prestasi terbaik, bahan tambahan harus ditambah ke dalam pengisaran terlebih dahulu, diikuti oleh pigmen. Campurkan terlebih dahulu komponen resin dan pelarut pengisaran, kemudian perlahan-lahan tambah bahan tambahan sambil mengacau. Jangan tambah pigmen sehingga bahan tambahan dicampur dengan baik.

If the order is wrong, it can be remedied by post-addition, but it needs to be added slowly under high shear conditions.