Chất phân tán dầu HH7025F

• HH7025F Oily dispersant

This compound is a slightly yellow fine particle, non-toxic, no side effects on the human body, insoluble in most solvents at room temperature, stable to acid, alkali and water media, soluble in hot chlorinated hydrocarbons and aromatic hydrocarbon solvents, its powder has a strong greasy feeling, and is wettable to water above 80℃.

• Dữ liệu sản phẩm

Cấu tạo

Contains ultra-large molecular polymers.

Tính chất tiêu biểu：

Bề ngoài: white powder

Initial melting point: 141～146℃

Total amine value: ≤3.0mg KOH/g

Color value: ≤5.0

Giá trị axit: ≤7.0mg KOH/g

Heating loss: ≤0.5%

Flash point: ≥28℃

Type: HH7025F

*.The values indicated in this data sheet describe typical properties and do not constitute specification limits.

• Ứng dụng

Special Features and Benefits

• Melting point increaser for petroleum products;
• Lubricant and corrosion inhibitor for metal wire drawing;
• Potting material for electrical components;
• Defoamer and paper coating component for papermaking industry;
• Defoamer and permanent water-removing agent for dyeing engineering in textile dyeing and finishing;
• Adding this product to asphalt can reduce the viscosity of asphalt, improve the softening point, water resistance and weather resistance of asphalt.

• Khuyến nghị sử dụng

HH7025F oily powder dispersant is used in plastics, chemical fibers, release agents, pigments, filler dispersants, powder coatings, Lớp phủ, inks and other uses.

Số tiền bổ sung

Recommended dosage: 3-5%

*. Dữ liệu trên là liều lượng thực nghiệm, và liều lượng tối ưu cần được xác định thông qua một loạt các thử nghiệm.

Hướng dẫn thành lập và xử lý

To achieve the best performance, the additives should be added to the grind first, followed by the pigment. Premix the resin and solvent components of the grind, then slowly add the additives while stirring. Do not add the pigment until the additives are well mixed.

If the order is wrong, it can be remedied by post-addition, but it needs to be added slowly under high shear conditions.