Madulas na nagkalat na HH7025F

• HH7025F Oily dispersant

This compound is a slightly yellow fine particle, non-toxic, no side effects on the human body, insoluble in most solvents at room temperature, stable to acid, alkali and water media, soluble in hot chlorinated hydrocarbons and aromatic hydrocarbon solvents, its powder has a strong greasy feeling, and is wettable to water above 80℃.

• Data ng produkto

Komposisyon

Contains ultra-large molecular polymers.

Karaniwang mga katangian：

Hitsura: white powder

Initial melting point: 141～146℃

Total amine value: ≤3.0mg KOH/g

Color value: ≤5.0

Halaga ng acid: ≤7.0mg KOH/g

Heating loss: ≤0.5%

Flash point: ≥28℃

I -type: HH7025F

*.Ang mga halagang ipinahiwatig sa sheet ng data na ito ay naglalarawan ng mga tipikal na katangian at hindi bumubuo ng mga limitasyon ng pagtutukoy.

• Mga Aplikasyon

Mga espesyal na tampok at benepisyo

• Melting point increaser for petroleum products;
• Lubricant and corrosion inhibitor for metal wire drawing;
• Potting material for electrical components;
• Defoamer and paper coating component for papermaking industry;
• Defoamer and permanent water-removing agent for dyeing engineering in textile dyeing and finishing;
• Adding this product to asphalt can reduce the viscosity of asphalt, improve the softening point, water resistance and weather resistance of asphalt.

• Inirerekumendang paggamit

HH7025F oily powder dispersant is used in plastics, chemical fibers, release agents, mga pigment, filler dispersants, powder coatings, coatings, inks and other uses.

Halaga ng karagdagan

Recommended dosage: 3-5%

*. The above data are empirical dosages, and the optimal dosage needs to be determined through a series of tests.

Incorporation and Processing Instructions

To achieve the best performance, the additives should be added to the grind first, followed by the pigment. Premix the resin and solvent components of the grind, then slowly add the additives while stirring. Do not add the pigment until the additives are well mixed.

If the order is wrong, it can be remedied by post-addition, but it needs to be added slowly under high shear conditions.